Kapinexä Specifications and Current Price List

• Dimensional Tolerances: ± .03 inch Standard
• Nominal Heater Thickness: .007 inch
• Dielectric: 1500 VRMS
• Temperature: -80⁰ F to 500⁰F
• Operating Voltage: 0 to 480 VAC or VDC
• Environmental: MIL-E-5272C
• Weight: .095 Lb/Ft²
• Leads: MIL-W-16878 Type E are Standard
• Adhesive: Pressure sensitive available
• Outgassing: Less than 1% weight loss at 392⁰F in a vacuum of 3 x 10 ^-6 Torr.
• Heat Capacities of 2 Watts/in² , 5 Watts/in² , and 10 Watts/in² available

Please Contact the Factory for Current Pricing. 

Note: Electrofilm Mfg Co. can supply any watt density requested. However, the heater temperature must be controlled withing the limits established above. Continuous operation above these temperatures will cause degradation of the materials used in the heater construction.

* - Watts are calculated @ 115VAC

Lead configuration Both lead wires out same end

2W/in²

2W/in² heaters will reach about 175^o in still air. Use these heaters to conserve electrical power and without controls in any of your warming appliations

5W/in²

5W/in² heaters will reach about 350^o in still air. Use for general purpose heating applications.

10W/in²

10W/in² heaters will reach 450^o in still air in 4 minutes. Higher temperatures will destroy the heater so this series should only be used with suitable heater controls.